[EXTERNAL] Juniper configuration recommendations/BCP

Thu Oct 8 14:57:46 UTC 2020

If using loopbacks on the router you have to have a firewall filter on it to permit traffic to the device even if you have a firewall filter on individual interfaces that would allow/deny traffic

From: NANOG <nanog-bounces+jamann=mt.gov at nanog.org> On Behalf Of Forrest Christian (List Account)
Sent: Thursday, October 8, 2020 3:38 AM
To: nanog list <nanog at nanog.org>
Subject: [EXTERNAL] Juniper configuration recommendations/BCP

<ISP hat on>
After nearly 30 years of being a cisco shop, I'm working on configuring our first pair of Juniper MX204's to replace our current provider-edge cisco.

I've worked through enough of the Juniper documentation/books to have a fairly good handle on how to configure these, but I wanted to check with the list to see if there are any Juniper-Specific gotchas I might run into that isn't documented well.

I've done a bit of googling and am either finding stuff that is largely Cisco-specific or which is generic - all of which I'm rather familiar with based on my past history.   Is there anything I should worry about which is Juniper-specific?

--
- Forrest
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mailman.nanog.org/pipermail/nanog/attachments/20201008/491d2873/attachment.html>