<div dir="ltr">This.<div><br></div><div>I've had some timing issues ( unrelated to NTP ) with certain combinations of FlightAware RTLSDR USB sticks and Pi models. IIRC USB and Ethernet share the same bus on the Pis, and that can cause bumps. </div><div><br></div><div>GPIOs run right off the SOC, avoiding that. </div></div><br><div class="gmail_quote"><div dir="ltr" class="gmail_attr">On Fri, Jun 21, 2019 at 7:25 AM Denys Fedoryshchenko <<a href="mailto:nuclearcat@nuclearcat.com">nuclearcat@nuclearcat.com</a>> wrote:<br></div><blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex">On 2019-06-21 14:19, Niels Bakker wrote:<br>
> * <a href="mailto:jay@west.net" target="_blank">jay@west.net</a> (Jay Hennigan) [Fri 21 Jun 2019, 05:19 CEST]:<br>
>> On 6/20/19 07:39, David Bass wrote:<br>
>>> What are folks using these days for smaller organizations, that need <br>
>>> to dole out time from an internal source?<br>
>> <br>
>> If you want to go really cheap and don't value your time, but do value <br>
>> knowing the correct time, a GPS receiver with a USB interface and a <br>
>> Raspberry Pi would do the trick.<br>
> <br>
> Have you tried this?  Because I have, and it's absolutely terrible.<br>
> GPS doesn't give you the correct time, it's supposed to give you a<br>
> good 1pps clock discipline against which you can measure your device's<br>
> internal clock and adjust accordingly for drift due to it not being<br>
> Cesium-based, influenced by room temperature etc.<br>
> <br>
> You're unlikely to get the 1pps signal across USB, and even then<br>
> there'll likely be significant latencies in the USB stack compared to<br>
> the serial interface that these setups traditionally use.<br>
<br>
I think it depends on recipe you are using.<br>
Raspberry have low latency GPIO, and some receivers have 1pps output.<br>
<a href="https://www.satsignal.eu/ntp/Raspberry-Pi-NTP.html" rel="noreferrer" target="_blank">https://www.satsignal.eu/ntp/Raspberry-Pi-NTP.html</a><br>
</blockquote></div>