CPE that support 1G with BGP multihomed
ahad at swiftelnetworks.com
Tue Sep 26 14:00:13 UTC 2017
I've personnel tested similar requirements on the followings;
ASR1001 - 8G RAM
ASR1002 8G RAM
with two eBGP sessions / full routes via two upstreams and mutiple iBGP
sessions to the core. The ASR1K is a safe bet.
The ISR G2 2921 or 2951 suffers under load if you have PBR or NAT/PAT rules.
Hope this info helps with your research and router selections.
On Tue, Sep 26, 2017 at 7:29 PM, marcel.duregards--- via NANOG <
nanog at nanog.org> wrote:
> Dear Nanoger,
> Anyone have an advice on CPE which can support the following features,
> 1 Gigabits/s ipv4 or ipv6 forwarding IMIX or Internet traffic, full
> duplex (not sure if cisco or miercom are conducting bidirectionals
> traffic flows at the same time).
> with ACLs and with uRPF
> with prefix filtering
> with bgp ext-communities (rfc 8092 would be a ++, but not mandatory)
> with BGP full route, 1 eBGP session + 1 iBGP (--> multihomed, single
> attached solution, so there is 2 CPE connected to 2 bgp transit))
> vrf light and
> SNMP + telnet/ssh with ACLs
> Currently on Cisco side, we see the following candidates:
> - ASR 1001-x
> - ASR 1002
> - ISR 4431, 4451
> - ISR G2 2921 + 2951 + 3925(E) (EoL soon, so we are currently in the
> process of evaluating other solution).
> But we would like also to include other manufacturer : juniper, mikrotik
> , etc....
> Thank for your help,
More information about the NANOG