OT: Below grade fiber interconnect points
jmcleod at musfiber.net
Thu Nov 14 13:28:11 UTC 2013
Your only other real option would be to deploy a "road-side" cabinet which has environmental controls...
From: Justin M. Streiner [mailto:streiner at cluebyfour.org]
Sent: Wednesday, November 13, 2013 9:05 PM
To: nanog at nanog.org
Subject: Re: OT: Below grade fiber interconnect points
On Wed, 13 Nov 2013, Roy Hockett wrote:
> Thank you for comments. Let me clarify the situation. We have a
> building that has been fiber cross connect location and is being
> demolished. This location has about 20 fiber cable entering where we
> patch between fiber paths. If we relocated these cross connect field
> to another building and that build is demolished we have to do this
> all over again, so the desire was to have an independent facility for
> the fiber cross connect field, but I am guessing due to esthetics the below ground vault was selected, we just learned of this selection and thus my query to this group to find other that have dealt with similar situations and if so, experience base recommendations, and things to be aware of.
If the vault has a controlled environment and access, similar to what you would find inside of a comms room, that's one thing. If it's more like a typical manhole (damp, dirty, dark, possible temperature extremes, other utilities/hazards), then the only thing that should be in there is a water-tight splice case. Fiber patches need to be in a clean environment.
Did this project provide any funds for relocation or replacement of the communications facilities that would be lost due to the demolition? We've gone through this many times on our campus.
This message has been scanned for viruses and dangerous content by MailScanner, and is believed to be clean.
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.
More information about the NANOG