Brocade XMR/MLX VLAN bit counters (Cacti graphs for brocade VLANS) (95% billing).

James Wininger jwininger at
Mon Jan 14 14:00:06 UTC 2013


We are running into an issue with Brocade where we are finding it difficult to to graph VLAN interfaces for bits (in/out) across a tagged (trunk) interface. On Cisco this is not an issue. So what we end up with in Cacti is a blank (no data) graph.

I have been all over these devices with snmpwalk etc (typical tool set). Has anyone found a "fix" or work around for this? Or perhaps I should be asking a different question….Is there a better tool/mindset for 95% billing since this is what we are doing with this info.

Jim Wininger

"Don't find fault, find a remedy." - Henry Ford

More information about the NANOG mailing list