BGP from Juniper to Cisco ASR
Philip Lavine
source_route at yahoo.com
Wed Dec 18 16:16:05 UTC 2013
yes I tried multihop
even though my peer is on the same /29
On Wednesday, December 18, 2013 8:10 AM, Eric Dugas <EDugas at zerofail.com> wrote:
Probably a TTL problem. Did you configure ebgp-multihop?
Eric Dugas
ZEROFAIL / AS40191
edugas at zerofail.com
-----Original Message-----
From: Philip Lavine [mailto:source_route at yahoo.com]
Sent: December 18, 2013 10:48 AM
To: NANOG list
Subject: BGP from Juniper to Cisco ASR
Dec 18 07:46:33: %BGP-3-NOTIFICATION: received from neighbor <REMOTE PEER> active 2/5 (authentication failure) 0 bytes Dec 18 15:46:33.615: BGP: ses global <REMOTE PEER> (0x7FB1CD209CF0:0) act Receive NOTIFICATION 2/5 (authentication failure) 0 bytes
Although I have seem this on the message boards I am little confused in that the ISP is telling me that there is no authentication enabled on the Juniper and I do not have authentication enabled on the ASR. So what is going on here?
More information about the NANOG
mailing list