ASR 1006 question

Fred Richards fredr at
Thu May 5 20:39:12 UTC 2011

Show the output of a "show interface" command.

On Thu, May 5, 2011 at 4:34 PM, Jeremy <jbaino at> wrote:

> Hey All,
> I think i may be noobing this one here, any help would be appreciated. We
> have an ASR1006 with a SIP and a 2x1gbps SPA. Right now we have:
>  2800 g0/0<----- -> ASR1006 g1/0/0
> All we're trying to do is set an IP address on each interface so we can
> ping
> ( on the 2800, on the ASR). We have the IPs
> configured on both but it's just not working. The 2800 is fine, if we
> attach
> a laptop to it and ping it works as expected. However when we attach the
> laptop to the ASR no ARP or ICMP messages are sent from the ASR, wireshark
> shows no traffice what so ever. The Interface is up/up and it was a fresh
> config, all we've done is add the IP address. Any thoughts? This shouldn't
> be this hard so I must be overlooking something silly.
Copy/Paste the output of a "show interface" command.


More information about the NANOG mailing list