<NAT translation from a sourced network to a destination network>

Mike Ruiz mruiz at lstfinancial.com
Fri Jun 18 20:38:48 UTC 2010

Also this needs to have access to my other prefixes.  It only needs to NAT'd when it needs to connect to that specific network.


From: Andrey Khomyakov [mailto:khomyakov.andrey at gmail.com] 
Sent: Friday, June 18, 2010 3:25 PM
To: Mike Ruiz
Cc: nanog at nanog.org
Subject: Re: <NAT translation from a sourced network to a destination network>


Do you mean you want certain addresses on /24 to NAT out to /27, but not all of them? Sounds like and ACL will do:



On Fri, Jun 18, 2010 at 4:13 PM, Mike Ruiz <mruiz at lstfinancial.com> wrote:

Ok here we go.  I know the subject is a little ambiguous, please allow to explain.

I have a network of and I need it to reach a network only when it needs to be accessed by specific machines that reside on the network. à NAT à10.0.1.10 à route that packet to

I only want specific host to route to that specific /27 network .

Any help would be appreciated. So far what I have gathered is only for VPN connections but I do not want to build a VPN.  Thank you again in advance.

Michael Ruiz

Network Engineer

"If you tell people where to go, but not how to get there, you'll be amazed at the results." -- General George S. Patton Jr.

Andrey Khomyakov
[khomyakov.andrey at gmail.com]

More information about the NANOG mailing list