Power/temperature monitoring

Frank Bulk - iNAME frnkblk at iname.com
Fri Jun 6 02:46:17 UTC 2008


Thanks.  The TemPager doesn't appear to support identifying AC power
failure, but that's in the Room Alert 7.  The price point and features do
seem reasonable.

 

Frank

 

From: Josh Fiske [mailto:jfiske at clarkson.edu] 
Sent: Wednesday, June 04, 2008 9:19 PM
To: frnkblk at iname.com; nanog at nanog.org
Subject: RE: Power/temperature monitoring

 

Frank,

We have had good luck with a device called TemPager (http://tempager.com/).
Our specific device is used for SNMP temperature monitoring, but they also
make a device that includes the ability to humidity, power, flood, room
entry, etc. etc.

Hope that is helpful,

Josh

- - - -
Joshua Fiske '03, '04
Network and Security Engineer
Clarkson University, Office of Information Technology
(315) 268-6722 -- Fax:  (315) 268-6570
GPG Key:  http://clarkson.edu/~jfiske/jfiske_pub.asc
jfiske at clarkson.edu

CONFIDENTIALITY:  This e-mail (including any attachments) may contain
confidential, proprietary and privileged information, and unauthorized
disclosure or use is prohibited.  If you received this e-mail in error,
please notify the sender and delete this e-mail from your system.



-----Original Message-----
From: Frank Bulk [mailto:frnkblk at iname.com]
Sent: Fri 5/30/2008 10:58 AM
To: nanog at nanog.org
Subject: Power/temperature monitoring

Hopefully monitoring the status of a network is on-topic.

I'm looking for temperature and power monitoring unit to install in some
remote BWA cabinets.  We had two incidents where we lost power in a town and
we weren't aware of it until the backup batter drained to empty, and another
situation where the cabinet became too cold.  Because these cabinets are
less than 19" wide and just 3-5" deep, I need something quite small.  I did
find one product but it requires four components (unit with built-in
temperature sensor, adapter, and AC power sensor, plus power supply)

Perhaps there's someone on this list who has gone down this road and can
point me to a good product.

Required:
- temperature sensor
- 110 VAC power monitoring (on/off, not necessarily current)
- Ethernet interface (at least SNMP, Web GUI and

Optional:
- fed via 12 VDC power
- 12 VDC power monitoring (current)
- humidity sensor


Frank







More information about the NANOG mailing list