IPv6 Training?
simon at limmat.switch.ch
simon at limmat.switch.ch
Thu May 31 23:29:24 UTC 2007
Alex Rubenstein writes:
> Does anyone know of any good IPv6 training resources (classroom, or
> self-guided)?
If your router vendor supports IPv6 (surprisingly, many do!):
lab-router#conf t
Enter configuration commands, one per line. End with CNTL/Z.
lab-router(config)#ipv6 ?
access-list Configure access lists
cef Cisco Express Forwarding for IPv6
dhcp Configure IPv6 DHCP
general-prefix Configure a general IPv6 prefix
hop-limit Configure hop count limit
host Configure static hostnames
icmp Configure ICMP parameters
local Specify local options
mfib Multicast Forwarding
mfib-mode Multicast Forwarding mode
mld Global mld commands
multicast-routing Enable IPv6 multicast
neighbor Neighbor
ospf OSPF
pim Configure Protocol Independent Multicast
prefix-list Build a prefix list
route Configure static routes
router Enable an IPV6 routing process
unicast-routing Enable unicast routing
lab-router(config)#ipv6 unicast-routing
lab-router(config)#interface tengigabitEthernet 1/1
lab-router(config-if)#ipv6 ?
IPv6 interface subcommands:
address Configure IPv6 address on interface
cef Cisco Express Forwarding for IPv6
dhcp IPv6 DHCP interface subcommands
enable Enable IPv6 on interface
mfib Interface Specific MFIB Control
mld interface commands
mtu Set IPv6 Maximum Transmission Unit
nd IPv6 interface Neighbor Discovery subcommands
ospf OSPF interface commands
pim PIM interface commands
policy Enable IPv6 policy routing
redirects Enable sending of ICMP Redirect messages
rip Configure RIP routing protocol
router IPv6 Router interface commands
traffic-filter Access control list for packets
unnumbered Preferred interface for source address selection
verify Enable per packet validation
lab-router(config-if)#ipv6 enable
[...]
And then chances are good that you find useful training material on
their Web sites, often not just command descriptions, but actual
deployment guides.
--
Simon.
More information about the NANOG
mailing list