2511 line break
Bruce Pinsky
bep at whack.org
Mon Jul 26 17:48:44 UTC 2004
-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1
Randy Bush wrote:
| on a 2511, which i am using as a serial console server for a bunch
| of boxes, how do i send a <break> on one of the lines?
|
The terminal emulation app that you use should have the capability to send
a telnet break to the terminal server. The terminal server in turn will
assert physical break on the line connected to the device.
There are a couple of line commands that can affect the behavior when
certain telnet commands are received. Specifically:
telnet break-on-ip
To cause the system to generate a hardware BREAK signal on the EIA/TIA-232
line that is associated with a reverse Telnet connection when a Telnet
Interrupt-Process command is received on that connection, use the telnet
break-on-ip command in line configuration mode.
telnet sync-on-break
To configure the Cisco IOS software to cause an incoming connection to
send a Telnet Synchronize signal when it receives a Telnet BREAK signal,
use the telnet sync-on-break command in line configuration mode. To disable
this function, use the no form of this command.
- --
=========
bep
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.2 (MingW32)
iD8DBQFBBUP8E1XcgMgrtyYRAlPNAJ4j/K5crtjriCSJMAHhKXeSEJKd5ACgrjHD
vzE7+4PiokLTJby/cV4kbJA=
=CBzv
-----END PGP SIGNATURE-----
More information about the NANOG
mailing list