More 6509 problems...

Sun Jan 28 16:49:04 UTC 2001

I don't believe that is the case.  According to Cisco, it is required to
make several of the line cards installable in the FlexWAN modules work
correctly.  I don't know what the details of distributed CEF are, but it
made my DS3s work, and that's the main thing I was looking for....  :-)

--Danny

-----Original Message-----
From: Berger, Gary [mailto:Gary.Berger at dowjones.com]
Sent: Tuesday, January 30, 2001 10:48 AM
To: agudgeon at firstnet.co.uk; 'Danny Snyder'; nanog at merit.edu
Subject: RE: More 6509 problems...

Correct me if I am wrong but I believe Distributed CEF is only applicable to
distributed line cards which need the X-Bar backplane.

Gary Berger
Internal Consultant, Principal
Dow Jones
Enterprise Network Services

-----Original Message-----
From: Alison Gudgeon [mailto:agudgeon at firstnet.co.uk]
Sent: Tuesday, January 30, 2001 11:36 AM
To: 'Danny Snyder'; nanog at merit.edu
Subject: RE: More 6509 problems...

Hi

Hybrid IOS

I've got IP CEF DISTRIBUTED set globally.  Did you have it enabled or
disabled on the T3 interface?

Ali

-----Original Message-----
From: Danny Snyder [mailto:dsnyder at nowdocs.com]
Sent: 30 January 2001 16:21
To: agudgeon at firstnet.co.uk; nanog at merit.edu
Subject: RE: More 6509 problems...

Alison,

I've had VERY similar problems with a 6509 (Sup 1a + MSFC2) with a FlexWAN
and a PA-2T3+.  After spending the better part of two weeks on the phone
with Cisco, we finally determined that ip cef distributed needed to be
turned on in global configuration.

Also, are you running native IOS or Catalyst OS on the Supervisor and IOS on
the MSFC ?

Danny Snyder
Network Administrator
NowDocs, Inc.

-----Original Message-----
From: owner-nanog at merit.edu [mailto:owner-nanog at merit.edu]On Behalf Of
Alison Gudgeon
Sent: Tuesday, January 30, 2001 10:18 AM
To: nanog at merit.edu
Subject: More 6509 problems...

Hi,

Is anyone doing the following:

6509 (supervisor 1a + msfc) - with a flexWAN adapter to take a Packet Over
Sonet OC-3 card.

I'm having great problems getting up/up on the interface, the current
situation is up/down, a hardware loop at the telco kit brings the line up/up
but otherwise just up/down.  Config is default I've just put IP's on.

I'm running very new code - 12.1(4)E1

many thanks in advance for any help.

Kind Regards

Alison