Need help with Cisco VLAN bridging....
Kent Yu
yux at lucent.com
Sat Feb 10 20:37:59 UTC 2001
Craig,
Apart from other suggestions, I think you also can do this:
1)Put ip address at both ends of the DS3;
2) Esbalish tunnels for each of your vlan using different loopback
interfaces;
3)put the vlans in their respective tunnles using brigde-group;
4) use rate limit based on the soure of loopback interface of the tunnel to
control how much each tunnel(vlan) can use the DS3;
Not sure wether you want to turn on the IRB, probably not.
Of course this is preety urgly using layer 3 to solve layer2 problem, but
just off the top of my head.
HTH
Kent Yu
----- Original Message -----
From: "Craig Holland" <cholland at yahoo-inc.com>
To: "Nanog at Merit. Edu" <nanog at merit.edu>
Sent: Friday, February 09, 2001 5:22 PM
Subject: Need help with Cisco VLAN bridging....
>
> Has anyone had experience bridging multiple VLANs accross a clear-channel
> DS3? I have 2 3640's populated with 1 FE and 1 HSSI. They are connected
by
> a DS3. I've tried a couple of different configs, including turning one
> router into a frame swich and building a PVC for each VLAN, but the
bridging
> didn't seem to work. I've tried running SDE directly between the HSSI
> ports...and that didn't seem to work. I'm up a against a deadline here,
and
> would greatly appreciate any help you can offer. I've also tried a couple
> of IRB configs.
>
> Thanks in advance,
> craig
>
>
>
> Craig Holland
> Network Engineer
> Yahoo! Inc.
> (408)731-3572
> Y!Messenger: cholland
>
>
More information about the NANOG
mailing list