How to loadshare over many E1 links
Martin, Christian
CMartin at mercury.balink.com
Fri Sep 18 16:31:03 UTC 1998
Jared,
I meant the latter. I knew that there were switch to switch FDX
capabilities - I'd never seen a router interface or NIC though. Cool.
Know any vendors off the top of your head???
-Chris
> -----Original Message-----
> From: Jared Mauch [mailto:jared at puck.nether.net]
> Sent: Friday, September 18, 1998 12:34 PM
> To: Martin, Christian; 'Scott Whyte'; 'Jesper Skriver';
> 'nanog at merit.edu'
> Cc: 'tdk-backbone at t.dk'
> Subject: Re: How to loadshare over many E1 links
>
>
> On Fri, Sep 18, 1998 at 12:17:47PM -0400, Martin, Christian wrote:
> > I didn't know there was any full-duplex 10BaseT spec...
>
> Yes there is. You need to have cards that support it,
> not everything does.
>
> Most modern switches support 10M fdx links, but not all
> router interfaces support them. Some pc cards support it, but
> not all.
>
> It does exist, but is not wideley used at all. Most people
> with that much traffic opt to use FE or Fddi
>
> - jared
>
> --
> Jared Mauch | pgp key available via finger from jared at puck.nether.net
> | http://puck.nether.net/~jared/
>
More information about the NANOG
mailing list