Router / Protocol Problem
Mike Walter
mwalter at 3z.net
Wed Sep 6 16:16:01 UTC 2006
Sorry, I am running iBGP. I just swapped out the NPE225 engine to a
NPE400 and 512MB and have not seen a change yet. I am still unable to
reach the sites. I am going to give it a while and sometime soon reboot
the other router. I removed the single /24 today out the one connection
to see if that would change anything as well.
Mike
-----Original Message-----
From: Hank Nussbacher [mailto:hank at efes.iucc.ac.il]
Sent: Wednesday, September 06, 2006 12:07 PM
To: Mike Walter
Cc: Justin M. Streiner; nanog at merit.edu
Subject: RE: Router / Protocol Problem
On Wed, 6 Sep 2006, Mike Walter wrote:
>
> Thanks for everyone's great input. Here are answers to Justin's
> questions.
>
> #1 - 12.3.6a - 7204VXR (NPE400) 512MB - 200+ MB free
> #2 - 12.2.15T5 - cisco 7204VXR (NPE225) - 256MB (I have a NPE400 -
512MB
> I want to swap in) - 23MB Free (Issue?)
>
> Full Routes from all peers. No internal routing protocol as of yet,
all
> static routes. Getting ready to implement OSPF. I have not rebooted
> the routers as a test. I have CEF on both routers. I have had some
> customers complaining about slowness.
No internal routing protocol? Not even iBGP? How do the 2 routers
exchange info? How do the internal systems know which router to exit
from? Or are they both independent?
I assume you are AS26241 and peer with 3356, 4323 and 6181.
I also assume you should be announcing your 2 prefixes:
69.4.64.0/20
216.68.104.0/21
but you have deaggregated a single /24 - 69.4.71.0/24 which has sent
34 BGP updates in the past 24 hours (which might be ok).
So, it is a bit hard to debug this with only partial info.
Regards,
Hank Nussbacher
http://www.interall.co.il
More information about the NANOG
mailing list