How to make setup backup route for windows server
Jason Lewis
jlewis at packetnexus.com
Tue Jun 18 01:30:42 UTC 2002
>
> The actual ips stay the same (they are on loopback interface on the
> windows server) so what is necessary is for cisco router to know if
> firewall is up and if so route that block of ips throuh the firewall
> and if not, then route it directly to the server through ethernet
> interface.
>
Are you asking how to configure failover on two NICs in a windows server
using a virtual IP?
Sorry I can't answer the windows question, but if that is what you are
looking for on Solaris. Check this article on samag.com.
http://www.samag.com/documents/s=1441/sam0111i/
jas
More information about the NANOG
mailing list